Modern homes ask more of their electrical systems every year. Between heat pumps, EV chargers, induction ranges, and a growing list of always-on devices, panels installed decades ago are being pushed well past what they were designed to carry.
Full-Service Electrical for Denver Metro Homes
Electrical work is the one trade in the home where a small shortcut can stay hidden for years and then cause a fire.
Our electricians work to current code, pull permits where they are required, and leave you with a system that an inspector, an insurer, and a future buyer will all accept. We cover the full range of residential electrical work, including the hard jobs.
Electrical Panel Upgrades and Service Replacements
Most Denver-area homes built before the 1990s were wired for a fraction of today’s load. If your panel is a 100-amp service, uses fuses rather than breakers, or carries a brand with a known failure history, a panel upgrade is usually the first thing worth doing.
A service upgrade also unlocks everything else: EV charging, a heat pump, a hot tub, a finished basement, or a shop circuit in the garage. We size the new service for what you plan to add as well as what you use today.
Wiring, Rewiring, and Code Corrections
We run new circuits for additions and remodels, replace deteriorated or undersized wiring, and correct the kind of work that turns up during a home inspection: open splices, missing junction boxes, ungrounded outlets, aluminum branch wiring, and circuits that were extended one too many times. If a real estate inspection has handed you a list, we can work straight off it.
Outlets, Switches, Lighting, and Ceiling Fans
Adding outlets where you actually need them, replacing failed switches, installing dimmers and smart switches, swapping fixtures, mounting ceiling fans, and putting in recessed or under-cabinet lighting. We also install GFCI and AFCI protection in the locations current code calls for, which is often the cheapest safety improvement available in an older house.
EV Charger Installation
Level 2 charger installation, including the load calculation that determines whether your existing service can carry it. This is the single most common reason Denver-area homeowners discover their panel is at capacity. We will tell you honestly whether you need a service upgrade first, instead of installing a charger onto a panel that cannot support it.
Whole-Home Surge Protection
A panel-mounted surge protective device guards everything downstream: the furnace control board, the air conditioner, the water heater, appliances, and electronics. Given what a single control board replacement costs, whole-home surge protection is one of the better-value additions in the house.
Generators and Backup Power
Standby and portable generator connections, transfer switches, and dedicated circuits for the equipment you most want to keep running through an outage. We size and wire the connection so that backup power is safe for you and for the line crews working on the grid.
Troubleshooting and Repair
Breakers that trip repeatedly, outlets that stop working, lights that flicker or dim when an appliance starts, burning smells, warm switch plates, and buzzing panels. These are diagnostic jobs, and we treat them that way: we find the actual cause rather than replacing parts until the symptom goes away.
Working With One Company Across Every Trade
Because Warm Welcome also handles heating, cooling, plumbing, and drains, electrical problems that cross trades do not turn into a scheduling problem for you. A furnace that will not start, a water heater on a failing circuit, or a bathroom remodel that needs venting, water, and power all get handled by one company with one point of contact.
If you have additional questions or need an electrician in the Denver metro, the team at Warm Welcome is ready to help. Call us or schedule online, and we will get an electrician out to diagnose the problem and give you a straight answer on what it will take to fix it.
$1000 Off
Any New System Install
- Valid for A/C, furnace, tankless water heater, or electrical panel replacement
- Free in-home estimate
- No pressure, no gimmicks
- Interest-free financing available
$99 Water Heater Flush
Tank or Tankless
- Normally $269
- Includes full inspection and maintenance
- Valid for either tank or tankless water heaters
$79 System Tune-Up
A/C or Furnace
- Normally $179
- Includes full inspection and tune-up
- Valid for either A/C or furnace depending on season
- Use now or save for later
Free Smart WiFi-Thermostat
- Receive a free Smart WiFi-Thermostat with purchase of a Membership Plan
- Must pay labor only for installation
- Must mention this coupon when purchasing Family Plan Membership
A Warm Welcome Within Your Budget
Big home repairs or replacements can be stressful. Our financing options make it easier to get expert service from our trained technicians while keeping your budget in mind. Let’s find a plan for comfort that works for you.
Frequently Asked Questions
How often should a home electrical system be professionally inspected?
A full inspection every three to five years is reasonable for most homes, and sooner if the house is more than forty years old, has had an addition or major remodel, or you are buying or selling. Older homes with original wiring benefit from a look after any significant load is added, such as a heat pump or EV charger.
What are the warning signs of a failing or overloaded electrical panel?
Breakers that trip repeatedly, a panel that feels warm or buzzes, scorch marks or a burning smell near the enclosure, lights that dim when a large appliance starts, and fuses rather than breakers. Panels from certain manufacturers have known failure histories and should be evaluated regardless of symptoms.
Why do my circuit breakers keep tripping?
A breaker doing its job means the circuit is drawing more current than it is rated to carry, usually from too many devices on one circuit. Repeated tripping on a light load points to something else: a failing breaker, a short, a ground fault, or damaged wiring. A breaker that trips often should be diagnosed, never replaced with a larger one.
Do I need a panel upgrade before installing an EV charger?
Often, yes. A Level 2 charger adds a substantial continuous load, and many Denver-area homes still have a 100-amp service already close to capacity. We run a load calculation before quoting, so you find out up front whether the existing panel supports it rather than after the work has started.
What should I do during an electrical emergency?
If you see sparking, smell burning, or find a hot outlet or switch, shut off the affected circuit at the panel, or the main breaker if you cannot identify it, and call us. Do not attempt to reset a breaker that trips immediately. If there is fire or smoke, leave the house and call 911 first.
